Genie GSD106 User Manual
                                        | |
Contents
| 
5Chapter 3 - Quick Operating GuideI. WiringII. Setting Protocol and Baud RateThe figure shows: Protocol: PELCO-D The figure shows: Auto detection protocol.Baud rate: 2400 bps Baud rate: 2400bps(Refer to detailed parameters in the next chapter)III. Setting Dome AddressThe figure shows: A Dome Address of 1(Refer to detailed parameters in the next chapter)This dip switch is located on the PCB in the domeIV. Install CameraNote: 1. Do not connect the camera and dome with FFC in an incorrect manner.2.The installation fixing holes of for different camera may differ.Set address for DomeProtocolSettingBaud RateSettingProtocolSettingBaud RateSettingTurn the power Off when setting, and restart the dome after revisionOrange RS485A (+)Yellow RS485B (-)Controller ofthe DomeYellow-Green Interphase ColourYellow-Green Interphase ColourBNC Video OutputRedBlackExternal Connection for Alarm Input/OutputAC24V InputConnected toGroundPower Supply of DomeDisplay |
Related manuals for Genie GSD106
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine