Genie GSD106 User Manual
                                        | |
Contents
| 
6V. Connect the Dome PowerWhen power is applied to the Dome the product enters a self-test routine which outputs the video image to anattached monitor.Note: When the dome is self-testing it is normal to hear sounds made by the Dome’s pan and tilt motors.VI. ControllerSet the communication protocol, baud rate and address of the keyboard controller. These must be identical tothose used for the Dome. Please refer to the Keyboard Controller instruction manual.Note: If the protocol for the Dome is set to auto detection, the protocol for the Keyboard Controller can be setarbitrarily, but the baud rate must be set identical with that of the Dome.VII. Start TestingWhen the above are complete, the Dome testing can be started.1. Direction Control Test 2. Zoom Control TestThe up, down, left and right directions of the The Camera Zoom can be controlled using theDome can be controlled by using the Joystick zoom function, or by the TELE (Zoom in)Keyboard Controller, as indicated above. and WIDE (Zoom out) keyboard buttons.VIII. Complete the Test1 If the test performance is normal it indicates the system is operating normally. Please do not make anychanges to the wiring and or settings. To do so may cause faults and/or unnecessary damage and loss.2 If the test performance is abnormal, or only one test is performing normally, please check the wiring (items 1and IV) and the settings (item II, III and VI).UpDownLeft Right Zoom InZoom OutRotate |
Related manuals for Genie GSD106
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine