Genie H8000-07 Operation And Maintenance Manual

Contents

Genie H8000-07 Operation And Maintenance Manual Manual pdf 8 page image

8 For Help, call 1-800-35-GENIE or visit www.geniecompany.comNOTEThe door must contact the 2” x 4” board before theCarriage activates the Close Limit Switch If not, readjustthe Close Limit SwitchS ettiNG C oNtaCt R eVeRSefuNCtioNAdjustment 2:NOTELimit Switch and Force Adjustments must be completedbefore checking the contact reverse function (Figure A-3)2” x 4” boardlaid flatFigure A-3 Checking Contact ReverseA Open garage door using Wall ConsoleB Lay a 2” x 4” board flat in center of doorwayC Close door using Wall ConsoleD Check that door stops and reverseswithin 2 seconds after itcontacts board:• If door does not reverse, decreaseClose Force until door reverses• If door still does not reverse, moveCLOSE Limit Switch toward doorE Check Safe-T-Beam® System operation:• If beam is blocked, door willnot closeTransmitter Compliance Statement A To program one Button of a Remote Control (Figure MA-1):• Locate Learn Button and Learn Indicator Lighton back side of Power Head under the Lens(Figure MA-2)• Press and release Learn Button Red LearnIndicator Light will blink 2 times per second• Press Remote Control Button once within 30seconds Red Learn Indicator Light will stay lit• Press Remote Control Button again Red LearnIndicator Light will go out, indicating thatmemory is storedB Program each additional Remote using step A above(up to seven remotes)NOTE• Each Remote Control must be programmedseparately• The Remote Controls will not cause the doorOpener to close the garage door if the Safe-T-Beam® System is malfunctioning• When programming the Remote Controls, theymust be at least 24” from the Antenna Wire• If the red Learn Indicator Light blinksapproximately 4 times per second,programming has stopped If programminghas stopped, repeat the above steps• Each Button on a 2 or 3 Button Remote Controlis for a different Opener You cannot use morethan one Button per Remote, per Opener• A maximum of seven Remote Controls orWireless Keypads can be stored into theReceiver at one time If a Remote Controlbecomes lost, or if you want to delete a RemoteControl or Wireless Keypad, see “To Erase AllReceiver Memory ”C pRoGRammiNG theR emote C oNtRolSProgramming 1:aCCeSSoRieSWARNING:A moving garage door may cause serious injury ordeath• Keep people clear of opening while door is moving• Do not allow children to play with the RemoteControlsIf the Safety Reverse does not work properly:• Close the door and disconnect the Opener usingthe Emergency Release Cord• Do not use the door Opener, Remote Controls, orWireless Keypad• Refer to the door and door Opener Owner’sManuals before attempting any repairs