Genie H8000-07 Operation And Maintenance Manual

Contents

Genie H8000-07 Operation And Maintenance Manual Manual pdf 9 page image

9For Help, call 1-800-35-GENIE or visit www.geniecompany.comLearn Code ButtonFigure MA-2 Learn Code Button and Indicator LightA Install two 60 Watt light bulbs (not included) into LightSockets (Figure MA-4):• Rough service, 130 Volt bulbs are recommendedB Install Lens into slots in Motor CoverC Install Genie Emergency Release Kit (GER-2) accessory,if purchasedD Installation is now completeLens1ASnap Lens Hinges intoslots on back of Motor Cover60 Wattsmaximum Push inLatchestoclose LensFigure MA-4 Install Lens Cover and LightBulbsTo Erase All Remotes from Power Head MemoryA Press and hold Learn Button on Power Head for 10seconds or until Learn Indicator Light goes outMemory is erased:• Program Transmitter/Receiver again as neededTo Replace Remote Control BatteryA FOR NON-FLASHLIGHT MODELS (Figure MA-3)• Pop off the back of the transmitter– Use coin, pen, screwdriver or any similar device– Replace old Battery with new coin type battery• Replace back of remote.B FOR FLASHLIGHT MODELS• Pry open battery cover (Notch built into cover )– Replace old Battery with new AAA battery• Snap shut battery cover.Remote Control OperationA Press Button on Remote Control Garage door will moveB Press Button again Garage door will stop:• The door automatically stops at the end of the open orclose cycleC Press Button again Garage door will reverse1 Button Compact Remotew/Docking StationFigure MA-1 Genie Remote Controls3 Button Compact Remotew/Docking StationTo program a Homelink® or Car2U Device:(This GDO is Homelink® and Car2U compatible)• Follow the Homelink® or Car2U instructions in your carowner’s manualiNStall liGht bulbS aND leNSWARNINGUse the Wall Console included with Opener Any otherwall console can cause the Opener to operate unexpect-edly and the light to stop workingFigure MA-3 Pry case open at the notch