Genie SC 1500, TriloG 1200 Operation & Maintenance Manual

Also see for CB 1000: Programming, operation & maintenance manual Maintenance manual Operation & maintenance manual Operation & maintenance manual

Contents

Genie SC 1500, TriloG 1200 Operation & Maintenance Manual Manual pdf 18 page image

18Maintenance and Adjustments6CAUTIONDoor closing force is FACTORY set and requires no adjustmentfor normal operation.sNEVER adjust the force settings to compensate for damage,including an unbalanced door, binding door track, or brokenspring.s0ERFORMMONTHLYA#/.4!#42%6%23%4%34See page 8.ADJUSTMENT GUIDESForce SettingsForce settings are pre programmed at the factory and “learned”during the Open/Close Limit settings steps (see pages 6-7). For normaluse, these settings should not need adjustment with this unit.However, conditions possibly requiring adjustment are:1. Doors with very stiff weather seals.2. Doors that start down, STOP, and reverse before closing.3. Doors that start up, but STOP before they completely open.Force Adjustment(continued next page)Force Level Powerhead LEDsROUND LEDLONG LEDLED indicator colors: OFF Blue Purple RedForce Level 1 BLUEBLUEBLUE BLUEOffOffOffOffForce Level 3Force Level 4 PURPLEPURPLEPURPLE PURPLEOffForce Level 6Force Level 7 REDREDREDREDOffForce Level 9Force Level 2Force Level 5Force Level 7PROGRAMSETPROGRAMSETThe Current UP FORCE SETTINGwill display. SEE CHART IN NEXTCOLUMN.Action LED Indication/ResultPress and holdboth up anddown buttons2 seconds or until roundLED turns RED.Press eitheruntil you reachdesired setting.Press andrelease.Press eitheruntil youreach thedesired setting.Press andrelease.USE CHART IN NEXT COLUMNUSE CHART INNEXT COLUMNLOCKS IN SETTING.Then the NewDOWN FORCESETTING will display.OFF RED OFF BLUEFlashes 3 TimesBLUEFlashingOFFBLUEBLUELOCKS IN SETTING.Both LEDs turnBLUE then OFFconfirms bothFORCE Settings are reset.BLUEBLUE OFF OFFFORCE SETTINGS DONE12345