Genie SC 1500, TriloG 1200 Operation & Maintenance Manual

Also see for CB 1000: Programming, operation & maintenance manual Maintenance manual Operation & maintenance manual Operation & maintenance manual

Contents

Genie SC 1500, TriloG 1200 Operation & Maintenance Manual Manual pdf 4 page image

4Features2SAFETY FEATURESSafe-T-Beam® (STB) Non-ContactReversing SystemPuts an invisible beam across the door opening.The door stops and reverses to the full openposition if anything passes through the beam.LED indicator lights on the powerhead and onthe STBs provide a self-diagnostic code if anoperational problem exists.Safe-T-Reverse® Contact Reversing SystemAutomatically stops and reverses a closing doorwithin two seconds of contact with an object.Automatic ForceGuard™ ControlAutomatically sets the force required to fullyopen and close the door for maximum safety.Watch Dog™ Monitoring SystemMonitors the Safe-T-Beam® system to ensureproper functionality and will automatically stopand reverse a closing door if a problemis detected.Manual Emergency ReleaseManually releases door from door opener. Usedduring a power failure or other emergency toallow manual opening and closing of door.SmartSet™ Electronic ProgrammingEasily adjust the programming to reduceopening speed to a desired rate, vary limitsand force, and program new remotes.Automatic Lighting SystemTwo bulb lighting system supplies light for saferevening exits and entries. Turns ON when door isactivated and automatically turns OFF 4 minuteslater.Integrated Motion Detection (Not available onall models)Some units have motion detection built into thepowerhead. Lights automatically turn ON whenmotion is detected for much safer movementthrough the garage. Lights will turn OFF after4 minutes of no motion.OPENER FEATURESINTELLICODE® 2 Access Security SystemA new generation superior encryption systemthat enhances the security of the door openerby continuously changing the access code eachtime the remote is used. The door opener re-sponds to each new code only once. An accesscode copied from a working system and triedagain, will not control the door opener.Wall ConsoleOperates door opener from inside garage.The wall console has an indicator light with:Open/Close, Sure-Lock™, and independentlight control buttons.Home Link and Car2U® compatible. Refer to theprogramming instructions on page 11.NOTE: Use this manual ONLY after completing assemblyand installation of opener. Review Assembly/InstallationInstructions poster. Check that all steps have beencompleted.Contact your Genie® Professional Dealer for anAssembly/Installation Instructions poster, if needed,or call 1-800-35GENIE. You can also go towww.geniecompany.com to download a printable file.Begin here ONLY AFTER completing assembly and installation of the opener. Review the Assembly and Installation poster to ensure all steps havebeen performed.There are no assembly or installation steps included in this manual. Contact your Genie® Professional Dealer for an installation poster, if needed,or call 1-800-35GENIE. You may also visit www.geniecompany.com to download a PDF file.INFRARED PROTECTION FUNCTION1. The Safe-T-Beam ® has no effect on the door during an opening cycle.2. If the Safe-T-Beam ® detects an obstruction when trying to close thedoor, it will not allow the door to close.3. When the garage door is closing, if Safe-T-Beam® is interrupted bya person or obstacle, the garage door will stop its downward traveland reverse automatically to its fully opened position.4. If the Safe-T-Beam® System fails, loses power, or is installedimproperly, press and hold the wall console “open/close” buttonuntil the door reaches its fully closed position. If you release the“open/close” button on the wall console during the closingmovement, the door will reverse automatically to its fully-openedposition.