Genie TZ-20 Operators Manual With Maintenance Information

Contents

Genie TZ-20 Operators Manual With Maintenance Information Manual pdf 36 page image

34 Genie TZ-34/20 Part No. 133554Operator’s Manual Fourth Edition • Fourth PrintingOperation from Ground1 Turn the key switch to ground control.2 Pull out the red Emergency Stop button tothe on position.3 Press and hold the yellowfunction enable button. Pressand hold the auto level button orthe individual outrigger buttonsto lower the outriggers and levelthe machine.4 Check the bubble level to make sure themachine is level.To Position Platform1 Push and hold the appropriate function enablebutton.2 Push and hold the boom function buttonaccording to the markings on the control panel.Operation from Platform1 Turn the key switch to platform control.2 Pull out both ground and platform redEmergency Stop buttons to the on position.To Position Platform1 Push and hold the appropriate function enablebutton.2 Push and hold the boom function buttonaccording to the markings on the control panel.3 If equipped: Rotatethe platform byturning the handcrank in eithera clockwise orcounterclockwisedirection.Do Not Operate Unless:You learn and practice the principles of safemachine operation contained in this operator’smanual.1 Avoid hazardous situations.2 Always perform a pre-operationinspection.3 Always perform function tests prior to use.4 Inspect the workplace.5 Only use the machine as it was intended.FundamentalsThe Operating Instructions section providesinstructions for each aspect of machine operation.It is the operator’s responsibility to follow all thesafety rules and instructions in the operator’smanual.Only trained and authorized personnel should bepermitted to operate a machine. If more than oneoperator is expected to use a machine at differenttimes in the same work shift, they must all bequalifi ed operators and are all expected to followall safety rules and instructions in the operator’s,safety and responsibilities manuals. That meansevery new operator should perform a pre-operationinspection, function tests, and a workplaceinspection before using the machine.Operating Instructions