Gentsys R3 Installation Manual
                                                        | |
Contents
| 
Pedestal Mount FeaturesSecure locking with no need for gate end stops.Can be used on both inward and outwardopening gates and on installations where spaceis limited.Provides the smoothest gate motion.Provides very secure locking and high security.Where a gate leaf width exceeds 3.0m a gate lockis recommended for security.Installation is independent of the size andstrength of gate pillar.Products required per gate leaf automation:1 x R3 or R5 operator.1 x R3 or R5 long linkage hardware kit(which includes drive arm, connecting arm,fasteners and bracket).1 x Pedestal.Operator InstallationOperator InstallationOperator InstallationPedestal Mount Installation(R3 and R5 operators)Wall Mount Installation(R3 operators only)Wall Mount FeaturesVery compact installation.Requires a pillar strong enough to support theoperator and potential loading if the gate isforced.Where a gate leaf width exceeds 2.5m a gate lockis recommended for optimum security.The operator may be mounted parallel orperpendicular to the pillar, whichever is bestsuited for the installation.Perpendicular installations are recommendedsince it inherently provides better locking andgreater security.Products required per gate leaf automation:1 x R3 or R5 operator.1 x R3 or R5 long linkage hardware kit(which includes drive arm, connecting arm,fasteners and bracket)1 x Wall mount bracket.Figure 6 Basic Installation OptionsLocate the Operator Position1. Swing the gate to the required open position and estimate the swing angle of the gate using the anglediagrams in Fig.7 to 11. Alternatively determine the gate swing angle by following the proceduredetailed on page 44.NOTE: Ensure that you use a LONG connectingarm for this type of installation.NOTE: Ensure that you use a SHORTconnecting arm for this type of installation.Page 15 |
manualsdatabase
Your AI-powered manual search engine