25Figure 19 Remove the slide railFigure 20 Install the DSIC cardRemoving a DSIC Interface CardAfter removing a DSIC card or when installing two SIC cards, you need to install a slide rail, whichseparates a DSIC slot into two SIC slots. Removal is in the reverse order of installation.Follow these steps to remove a DSIC card:Step1 Loosen the screws on the interface card and remove the card.Step2 Insert a slide rail into the slot and fasten the captive screws on the slide rail.Step3 Install a blank panel if no cards are to be installed in the slot.Verifying InstallationDuring router installation, you must verify installation each time you power on the router, making surethat:• There is enough space around the router for heat-dissipation and the workbench is stable enough.• The power supply matches the requirements of the router.• The PGND cable of the router is correctly connected.• The router is correctly connected to the console terminal and other devices.CAUTION:It is very important to verify the installation because the stability and grounding of the router and the powersupply will directly affect the operation of the router.
