H3C S3100V2 Series Installation Manual

Also see for S3100V2 Series: Installation, quick start

Contents

8Preparing for installationSafety recommendationsTo avoid possible bodily injury and equipment damage, read the safety recommendations in this chaptercarefully before installing an S3100V2 switch. The recommendations do not cover every possiblehazardous condition.General safety recommendations• Keep the chassis clean and dust-free. Do not clean the switch with wet cloth or liquid.• Do not place the switch on a moist area, and avoid liquid surrounding the switch.• Make sure that the ground is dry and flat and anti-slip measures are in place.• Do not place the switch on an unstable case or desk. The switch might be damaged severely in caseof a fall.• Keep the chassis and installation tools away from walk areas.• Do not wear loose clothing, jewelry (for example, necklace), or any other objects that could getcaught in the chassis when you install and maintain the switch.• Do not open the chassis to avoid electrical shocks when the switch is operating or just when theswitch is powered off.Safety with electricity• Clear the work area of possible hazards, such as ungrounded power extension cables, missingsafety grounds, and wet floors.• Make sure that the operating voltage is as required.• Locate the emergency power-off switch in the room before installation. Shut the power off at once incase accident occurs.• Unplug all the external cables (including power cords) before moving the chassis.• Always check that the power has been disconnected.ESD preventionTo prevent the electronic components from being damaged by the electrostatic discharge (ESD), youshould not only take ESD measures where the switch is located, but also take the following precautions:• Make sure the switch is well grounded. For how to ground the switch, see “Grounding the switch.”• Always wear an ESD-preventive wrist strap when installing hot swappable modules.Perform the following steps to use the ESD-preventive wrist strap:Step1 Wear the wrist strap on your wrist.Step2 Lock the wrist strap tight around your wrist to keep good contact with the skin.Step3 Attach the ESD-preventive wrist strap to a post on the rack or ground it by using other methods.