40Step Command Remarks4. Return to system view. quit N/A5. Create a behavior and enterbehavior view. traffic behavior behavior-name N/A6. Configure a traffic policingaction.car cir committed-information-rate [ cbscommitted-burst-size [ ebsexcess-burst-size ] ] [ pirpeak-information-rate ] [ green action ][ yellow action ] [ red action ]N/A7. Return to system view. quit N/A8. Create a policy and enterpolicy view. qos policy policy-name N/A9. Associate the class with thetraffic behavior in the QoSpolicy.classifier tcl-name behaviorbehavior-name N/A10. Return to system view. quit N/A11. Apply the QoS policy.• Applying the QoS policy to aninterface• Applying the QoS policy to onlineusers• Applying the QoS policy to a VLAN• Applying the QoS policy globally• Applying the QoS policy to thecontrol planeChoose one applicationdestination as needed.Configuring GTSThe Switch Series supports queue-based GTS, which shapes traffic of a specific queue.To configure GTS:Step Command Remarks1. Enter system view. system-view N/A2. Enter interface view or portgroup view.• Enter interface view:interface interface-typeinterface-number• Enter port group view:port-group manualport-group-nameUse either command.Settings in interface view take effect onthe current interface. Settings in portgroup view take effect on all ports in theport group.3. Configure GTS for a queue.qos gts queue queue-number circommitted-information-rate [ cbscommitted-burst-size ]N/AConfiguring the rate limitThe rate limit of a physical interface specifies the maximum rate of outgoing packets.
