H3C S5130-EI Series Installation Manual

Also see for S5130-28F-EI: Configuration guide

Contents

H3C S5130-EI Series Installation Manual Manual pdf 51 page image

44Appendix B FRUsThe S5130-28F-EI switch provides two power module slots. One power module can meet the powerrequirement of the switch. You can install two power modules on the switch for redundancy. Table 11describes the power modules available for the S5130-28F-EI switch.Table 11 Power modules available for the S5130-28F-EI switchPower modulemodel Item Specification Remarks• PSR150-A1• PSR150-AAC inputRated input voltage 100 VAC to 240 VAC@ 50 Hz or 60 HzFor moreinformationabout the powermodules, seeH3C PSR150-A& PSR150-DSeries PowerModules UserManual.Max input voltage 90 VAC to 264 VAC@ 47 Hz to 63 HzHigh-voltage DCinput (supportedonly by thePSR150-A1power module)Rated input voltage 240 VDCMax input voltage 180 VDC to 320 VDCMax output power 150 WPSR150-D1Rated input voltage –48 VDC to –60 VDCMax input voltage –36 VDC to –72 VDCMax output power 150 WWhen two power modules are installed, you can hot-swap a power module. To avoid device damageand bodily injury, follow the procedures in Figure 14 and Figure 15 to install and remove the powermodule.