H3C S5500-EI Configuration Manual

Also see for S5500-EI series: Operation manual Operation manual Operation manual – port security Configuration guide Operation manual

Contents

H3C S5500-EI Configuration Manual Manual pdf 133 page image

116[SwitchA] display ospf interfaceOSPF Process 1 with Router ID 1.1.1.1InterfacesArea: 0.0.0.0IP Address Type State Cost Pri DR BDR192.168.1.1 Broadcast DR 1 100 192.168.1.1 192.168.1.3[SwitchB] display ospf interfaceOSPF Process 1 with Router ID 2.2.2.2InterfacesArea: 0.0.0.0IP Address Type State Cost Pri DR BDR192.168.1.2 Broadcast DROther 1 0 192.168.1.1 192.168.1.3NOTE:The interface stateDROther means the interface is not the DR/BDR.Configuring OSPF virtual linksNetwork requirementsIn Figure 44, Area 2 has no direct connection to Area 0, and Area 1 acts as the Transit Area to connectArea 2 to Area 0 via a configured virtual link between Switch B and Switch C.After configuration, Switch B can learn routes to Area 2.Figure 44 Network diagramArea 0Swtich AVlan-int30010.1.1.1/24Swtich BSwitch CSwitch D Area 2Vlan-int30010.1.1.2/24Vlan-int10010.3.1.2/24Vlan-int10010.3.1.1/24Virtual linkVlan-int20010.2.1.1/24Vlan-int20010.2.1.2/24Area 1Configuration procedure1. Configure IP addresses for interfaces. (Details not shown)2. Configure OSPF basic functions.# Configure Switch A. system-view[SwitchA] ospf 1 router-id 1.1.1.1[SwitchA-ospf-1] area 0[SwitchA-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255