H3C S5500-EI Series Configuration Manual

Also see for S5500-EI series: Operation manual Operation manual Configuration guide Operation manual – port security Configuration guide

Contents

H3C S5500-EI Series Configuration Manual Manual pdf 44 page image

31MAC Information configuration exampleNetwork requirements• Host A is connected to a remote server (Server) through Device.• Enable MAC Information on GigabitEthernet 1/0/1 on Device. Device sends MAC addresschanges in Syslog messages to Host B through GigabitEthernet 1/0/3. Host B analyzes anddisplays the Syslog messages.Figure 6 Network diagram for MAC Information configurationConfiguration procedure1. Configure Device to send Syslog messages to Host B.For more information, see the Network Management and Monitoring Configuration Guide.2. Enable MAC Information.# Enable MAC Information on Device. system-view[Device] mac-address information enable# Configure MAC Information mode as Syslog.[Device] mac-address information mode syslog# Enable MAC Information on GigabitEthernet 1/0/1.[Device] interface gigabitethernet 1/0/1[Device-GigabitEthernet1/0/1] mac-address information enable added[Device-GigabitEthernet1/0/1] mac-address information enable deleted[Device-GigabitEthernet1/0/1] quit# Set the MAC Information queue length to 100.[Device] mac-address information queue-length 100# Set the interval for sending Syslog or trap messages to 20 seconds.[Device] mac-address information interval 20