40NOTE:• If a port is used as a reflector port for port mirroring, do not assign it to any aggregation group. Formore information about reflector ports, see theNetwork Management and Monitoring ConfigurationGuide.• To achieve better load sharing results for data traffic among the member ports of a link aggregationgroup, assign ports of the same type (such as all 100 Mbps ports or all GE ports and so on) to the linkaggregation group.CAUTION:Removing an aggregate interface also removes the corresponding aggregation group. At the same time,all member ports leave the aggregation group.Configuring a static aggregation groupNOTE:To guarantee a successful static aggregation, ensure that the ports at both ends of each link are in thesame aggregation state.Follow these steps to configure a Layer 2 static aggregation group:To do... Use the command... RemarksEnter system view system-view —Create a Layer 2 aggregateinterface and enter the Layer 2aggregate interface viewinterface bridge-aggregationinterface-numberRequiredWhen you create a Layer 2aggregate interface, the systemautomatically creates a Layer 2static aggregation groupnumbered the same.Exit to system view quit —Enter Layer 2 Ethernet interfaceviewinterface interface-typeinterface-numberAssign the Ethernet interface to theaggregation groupport link-aggregation groupnumberRequiredRepeat these two steps to assignmultiple Layer 2 Ethernet interfacesto the aggregation group.Configuring a dynamic aggregation groupNOTE:To guarantee a successful dynamic aggregation, make sure that the peer ports of the ports aggregated atone end are also aggregated. The two ends can automatically negotiate the aggregation state of eachmember port.Follow these steps to configure a Layer 2 dynamic aggregation group:To do... Use the command... RemarksEnter system view system-view —
