H3C S5510 Series Installation Manual

Also see for S5510 Series: Configuration Operation manual Operation manual Operation manual Command manual

Contents

H3C S5510 Series Installation Manual Manual pdf 58 page image

Installation ManualH3C S5510 Series Ethernet Switches Chapter 5 Loading Boot ROM and Host Software5-9Checking flash......done!III. Loading host softwareFollow these steps to download host software of the switch.Step 1: Select <1> in the Boot Menu. The system displays the following information:1. Set TFTP protocol parameter2. Set FTP protocol parameter3. Set XMODEM protocol parameter0. Return to boot menuEnter your choice(0-3):3Select <1>. The subsequent steps are the same as those for loading Boot ROM, exceptfor the program to be downloaded in prompt messages.5.2.4 Loading Software from an Ethernet Port Using FTPI. Introduction to FTPWith an Ethernet port, you can also use the switch as the FTP server or client todownload or configuration files. The following subsections describe how to loadsoftware by using the switch as the FTP client for example.II. Loading Boot ROMNote:In the process of loading Boot ROM, the switch can only act as the FTP client.Step 1: Select an Ethernet port on the switch for loading and connect it to the PC wherethe file to be downloaded is stored. (You must know PC’s IP address). Besides, connectthe Console port on the switch to an external PC. This PC can be the same one thatstores the file to be downloaded.Step 2: Run the FTP Server program on the PC that is connected to the Ethernet port,and specify the path for program loading.Step 3: Run terminal emulation program on the PC connected to the Console port. Startthe switch, access the Boot Menu, and then enter the download protocol menu.To download the Boot ROM program, enter <6> or to access the menu forBoot ROM downloading when the system displays: “Enter your choice(0-9):”Bootrom update menu:1. Set TFTP protocol parameter2. Set FTP protocol parameter