9-9To do… Use the command… RemarksEnter OSPFv3 view ospfv3 [ process-id ] —Enter OSPFv3 area view area area-id —Configure a summary route abr-summary ipv6-addressprefix-length [ not-advertise ]RequiredNot configured by defaultThe abr-summary command takes effect on ABRs only.Configuring OSPFv3 Inbound Route FilteringYou can configure OSPFv3 to filter routes that are computed from received LSAs according to somerules.Follow these steps to configure OSPFv3 inbound route filtering:To do… Use the command… RemarksEnter system view system-view —Enter OSPFv3 view ospfv3 [ process-id ] —Configure inbound routefilteringfilter-policy { acl-number | ipv6-prefixipv6-prefix-name } importRequiredNot configured by defaultUse of the filter-policy import command can only filter routes computed by OSPFv3. Only routes notfiltered out can be added into the local routing table.Configuring an OSPFv3 Cost for an InterfaceYou can configure an OSPFv3 cost for an interface with one of the following two methods:z Configure the cost value in interface view.z Configure a bandwidth reference value for the interface, and OSPFv3 computes the costautomatically based on the bandwidth reference value: Interface OSPFv3 cost = Bandwidthreference value/Interface bandwidth. If the calculated cost is greater than 65535, the value of65535 is used.
