H3C S5820X Series Acl And Qos Command Reference
Also see for s5800 series: Installation manualInstruction manualCommand referenceQuick startTroubleshooting guide
                                                                                                                                        | |
Contents
| 
77Table 27 Output descriptionField DescriptionInterface Interface type and interface numberRule(s) Match criteriaCIR Committed information rate (CIR) in kbpsCBS Committed burst size in bytes, which specifies the depth of the tokenbucket for holding traffic burstsqos gtsSyntaxqos gts queue queue-number cir committed-information-rate [ cbs committed-burst-size ]undo qos gts queue queue-numberViewLayer 2 Ethernet interface view, Layer 3 Ethernet interface view, port group viewDefault level2: System levelParametersqueue queue-number: Shapes the packets in the specified queue. The queue-number argument rangesfrom 0 to 7.cir committed-information-rate: Sets the committed information rate (CIR) in kbps, which specifies theaverage traffic rate. The CIR must be a multiple of 8 and ranges from 8 to 1000000 for a GE port and8 to 10000000 for a 10-GE port.cbs committed-burst-size: Committed burst size (CBS) in bytes.• If you do not specify the cbs keyword, the CBS is 62.5 × committed-information-rate by default andmust be a multiple of 512. If 62.5 × committed-information-rate is not a multiple of 512, the closesthigher multiple of 512 applies.• If you specify the cbs keyword, the CBS ranges from 512 to 16777216 and must be a multiple of 512.DescriptionUse the qos gts command to set GTS parameters for the packets in a specific queue.Use the undo qos gts command to remove GTS parameters for a specific class of traffic or all the trafficon the interface or port group.By default, no GTS parameters are configured on an interface.Settings in interface view take effect on the current interface. Settings in port group view take effect on allports in the port group.Examples# Configure GTS for traffic of queue 2 on GigabitEthernet 1/0/1 using the following parameters: CIR is640 kbps. |
Related manuals for H3C s5800 series
H3C S5820X Series Irf Command Reference
H3C S5820X Series Oaa Command Reference
H3C S5820X Series Command Reference Manual
H3C S5820X Series Command Reference Manual
H3C S5820X Series Command Reference Manual
H3C S5820 Series Oaa Command Reference
H3C S5820 series Command Reference Manual
H3C S5830V2 Series Mce Command Reference
H3C S5830V2 Series Command Reference Manual
H3C S6800 Series Mce Command Reference
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine