H3C S7500 Series Operation Manual

Also see for S7500 Series: Operation manual Operation manual Operation manual Operation manual Command manual

Contents

H3C S7500 Series Operation Manual Manual pdf 12 page image

Operation Manual – System Maintenance and DebuggingH3C S7500 Series Ethernet SwitchesChapter 1 Boot ROM and Host SoftwareLoading1-10Loading........................................doneBootrom updating..........done!III. Loading host softwareFollow these steps to load the host software.Step 1: Select <1> in Boot Menu and press . The system displays the followinginformation:1. Set TFTP protocol parameter2. Set FTP protocol parameter3. Set XMODEM protocol parameter0. Return to boot menuEnter your choice(0-3):3Step 2: Enter 1 in the above menu to download the host software using TFTP.The subsequent steps are the same as those for loading the Boot ROM program,except that the system gives the prompt for host software loading instead of Boot ROMloading.Caution:When loading Boot ROM and host software using Boot menu, you are recommended touse the PC directly connected to the device as TFTP server to promote upgradingreliability.1.2.4 Loading Software Using FTP through Ethernet PortI. Introduction to FTPFTP is an application-layer protocol in the TCP/IP protocol suite. It is used for filetransfer between server and client, and is widely used in IP networks.You can use the switch as an FTP client or a server, and download software to theswitch through an Ethernet port. The following is an example.II. Loading Process Using FTP Clientz Loading Boot ROM software

/ 41

Related manuals for H3C S7500 Series

H3C S7500 Series Operation Manual

This manual is suitable for:

S7500 Series

manualsdatabase

Your AI-powered manual search engine