H3C S7500 Series Operation Manual

Also see for S7500 Series: Operation manual Operation manual Operation manual Operation manual Command manual

Contents

H3C S7500 Series Operation Manual Manual pdf 38 page image

Operation Manual – System Maintenance and DebuggingH3C S7500 Series Ethernet Switches Chapter 4 Device Management4-10To do… Use the command… RemarksEnter Ethernet interfaceviewinterface interface-typeinterface-number —Enable error packetsmonitoringqe monitor errpkt { all |none | runt }Required.If you specify the keywordall in the command, theswitch detects all errorpackets on currentinterface.If you specify the keywordrunt, the switch onlydetects error packets thatare of runt type on currentinterface.If you specify the keywordnone, the switch does notdetect the error packetson current interface.4.6.2 Error Packets Monitoring Configuration ExampleI. Network requirementsz Enable error packets monitoring on Ethernet 4/0/1 interface and only the packetsthat are of runt type are concerned.z Set the interval for detecting error packets to 50 seconds.II. Configuration procedure# Enter system view. system-view[H3C]# Set the interval for detecting error packets to 50 seconds.[H3C] qe monitor errpkt check-time 50# Enter Ethernet interface view of Ethernet 4/0/1.[H3C] interface Ethernet 4/0/1[H3C-Ethernet4/0/1]# Specify only detect current interface for error packets of runt type.[H3C-Ethernet4/0/1] qe monitor errpkt runt

/ 41

Related manuals for H3C S7500 Series

H3C S7500 Series Operation Manual

This manual is suitable for:

S7500 Series

manualsdatabase

Your AI-powered manual search engine