157Configure port GigabitEthernet 3/0/1 of Switch A to allow only IP packets with the source MACaddress of 00-01-02-03-04-06 and the source IP address of 192.168.0.1 to pass.[SwitchA] interface gigabitethernet 3/0/1[SwitchA-GigabitEthernet3/0/1] user-bind ip-address 192.168.0.1 mac-address 0001-0203-04062. Configure Switch BConfigure the IP addresses of various interfaces (omitted).Configure port GigabitEthernet 3/0/2 of Switch B to allow only IP packets with the source MACaddress of 00-01-02-03-04-06 and the source IP address of 192.168.0.1 to pass. system-view[SwitchB] interface gigabitethernet 3/0/2[SwitchB-GigabitEthernet3/0/2] user-bind ip-address 192.168.0.1 mac-address 0001-0203-0406[SwitchB-GigabitEthernet3/0/2] quitConfigure port GigabitEthernet 3/0/1 of Switch B to allow only IP packets with the source MACaddress of 00-01-02-03-04-07 and the source IP address of 192.168.0.2 to pass.[SwitchB] interface gigabitethernet 3/0/1[SwitchB-GigabitEthernet3/0/1] user-bind ip-address 192.168.0.2 mac-address 0001-0203-04073. Verify the configurationOn Switch A, static binding entries are configured successfully. display user-bindTotal entries found: 2MAC IP Vlan Port Status0001-0203-0405 192.168.0.3 N/A GigabitEthernet3/0/2 Static0001-0203-0406 192.168.0.1 N/A GigabitEthernet3/0/1 StaticOn Switch B, static binding entries are configured successfully. display user-bindTotal entries found: 2MAC IP Vlan Port Status0001-0203-0406 192.168.0.1 N/A GigabitEthernet3/0/2 Static0001-0203-0407 192.168.0.2 N/A GigabitEthernet3/0/1 StaticDynamic IP source guard binding function configurationexample INetwork requirementsSwitch A connects to Client A and the DHCP server through ports GigabitEthernet 3/0/1 andGigabitEthernet 3/0/2 respectively. DHCP snooping is enabled on Switch A. See Figure 53.Detailed requirements are as follows:• Client A (with the MAC address of 00-01-02-03-04-06) obtains an IP address through theDHCP server.
