H3C S9800 Series Installation Manual

Also see for S9800 Series: Configuration Examples Configuration guide Manual

Contents

H3C S9800 Series Installation Manual Manual pdf 31 page image

24The installing and removing procedures are the same for the LSVM1S9800FAN andLSVM2S9800FAN fan trays.To install an LSVM1S9800FAN/LSVM2S9800FAN fan tray:1. Wear an ESD wrist strap, and make sure it makes good skin contact and is reliably grounded.2. Use a Phillips screwdriver to loosen the captive screws on the filler panel in the fan tray slot.3. Thread a flat-blade screwdriver through the handle on the filler panel and pull out the filler panelgently.Keep the filler panel secure for future use.4. Unpack the fan tray and verify that the fan tray model is correct.5. Holding the fan tray with both hands with the upside (marked with a "TOP" sign) up, gently pushthe fan tray into the slot along the guide rails until the fan tray completely seats into the slot. Seecallout 1 in Figure 30.To prevent damage to the fan tray or the connectors on the backplane, insert the fan tray gently.If you encounter resistance while inserting the fan tray, pull out the fan tray and insert it again.6. Use a Phillips screwdriver to tighten the captive screws on the fan tray to make sure the fan trayfully seats into the slot. See callout 2 in Figure 30.If the screws fail to be tightened, verify the installation of the fan tray.Figure 30 Installing the LSVM1S9800FAN/LSVM2S9800FAN fan trayInstalling the LSVM1S9810FAN/LSVM2S9810FAN fan trayfor the S9810 switchThe installing and removing procedures are the same for the LSVM1S9810FAN andLSVM2S9810FAN fan trays.Before you install LSVM1S9810FAN/LSVM2S9810FAN fan trays on an S9810 switch, follow theseguidelines:• Determine the required number of fan trays based on the number of installed switching fabricmodules. If one switching fabric module is installed, one fan tray is required (You must installthe fan tray in the lower fan tray slot). If two switching fabric modules are installed, two fan traysare required.• Make sure the airflow direction of the fan tray meets the ventilation requirement at theinstallation site.12222