Installation ManualH3C SecPath F1000-A Firewall Chapter 8 Multifunctional Interface Modules8-158.6.6 Connecting the Interface Fiber CableCaution:In connecting the fiber cable, observe the following:z Do not over-bend the fiber cable. Its curvature radius must be equal to or greaterthan 10 cm.z Ensure that the Tx and Rx ends are correctly connected.z Ensure that the fiber ends are clean.Caution:Laser danger: never look into the optical ports that are connected to the laser. It canharm your eyes.Step 1: Insert the shipped SFP module into the corresponding slot.Step 2: Identify the Rx and Tx optical ports on the 1GEF/2GEF module. Plug one end ofa fiber cable into the Rx port on the module and the other end into the Tx port on thepeer device. Plug one end of another fiber cable into the Tx port on the module, and theother end into the Rx port on the peer device.Step 3: Power up the firewall. Check the status of the LINK LED on the module panel.ON means an Rx link is present. OFF means no Rx link is present; check theconnection for the cause.8.7 SSL Module8.7.1 IntroductionThe SSL encryption module supports multiple types of hardware encryption/decryptionand Hash algorithms and provides high-performance and high-reliability encryptionfeatures by processing the SSL protocol, which is available on the module.When a SSL encryption module is inserted on a MIM slot, the mainboard receives andtransmits packets and processes the SSL protocol, while the SSL encryption moduleencrypts and decrypts packets.8.7.2 AppearanceFigure 8-21 shows the SSL module.
