84Task Command RemarksDisplay detailed information abouta specific or all aggregationgroups.display link-aggregation verbose[ { bridge-aggregation | route-aggregation }[ interface-number ] ] [ | { begin | exclude |include } regular-expression ]Available in any viewClear LACP statistics for a specificor all link aggregation memberports.reset lacp statistics [ interface interface-list ] Available in userviewClear statistics for a specific or allaggregate interfaces.reset counters interface [ { bridge-aggregation |route-aggregation } [ interface-number ] ]Available in userviewEthernet link aggregation configuration examplesNOTE:In an aggregation group, only ports that have the same port attributes and class-two configurations (see“Configuration classes”) as the reference port (see “Reference port”) can operate as Selected ports. Makesure that all member ports have the same port attributes and class-two configurations as the referenceport. The other settings only need to be configured on the aggregate interface, not on the member ports.Layer 2 static aggregation configuration exampleNetwork requirementsAs shown in Figure 26:• Configure a Layer 2 static aggregation group on Device A and Device B respectively, enable VLAN10 at one end of the aggregate link to communicate with VLAN 10 at the other end, and VLAN 20at one end to communicate with VLAN 20 at the other end.• Enable traffic to be load-shared across aggregation group member ports based on the source anddestination MAC addresses.Figure 26 Network diagramConfiguration procedure1. Configure Device A:
