86AGG AGG Partner ID Select Unselect ShareInterface Mode Ports Ports Type-------------------------------------------------------------------------------BAGG1 S none 3 0 SharThe output shows that link aggregation group 1 is a load shared Layer 2 static aggregation groupand it contains three Selected ports.# Display the global link-aggregation load sharing criteria on Device A.[DeviceA] display link-aggregation load-sharing modeLink-Aggregation Load-Sharing Mode:destination-mac address, source-mac addressThe output shows that all link aggregation groups created on the device perform load sharingbased on source and destination MAC addresses.Layer 2 dynamic aggregation configuration exampleNetwork requirementsAs shown in Figure 27:• Configure a Layer 2 dynamic aggregation group on Device A and Device B respectively, enableVLAN 10 at one end of the aggregate link to communicate with VLAN 10 at the other end, andVLAN 20 at one end to communicate with VLAN 20 at the other end.• Enable traffic to be load-shared across aggregation group member ports based on source anddestination MAC addresses.Figure 27 Network diagramConfiguration procedure1. Configure Device A:# Create VLAN 10, and assign the port GigabitEthernet 4/1/4 to VLAN 10. system-view[DeviceA] vlan 10[DeviceA-vlan10] port gigabitethernet 4/1/4[DeviceA-vlan10] quit
