41Memory Size : 4096MBMemory Speed : 533MHzBootWare Size : 1536KBFlash Size : 4MBcfa0 Size : 247MBCPLD Version : 3.0PCB Version : Ver.BBootWare Validating...Press Ctrl+B to enter extended boot menu...Starting to get the main application file--cfa0:/main.bin!........................................................................................................................................................................The main application file is self-decompressing................................Press ENTER to get started.Press Enter at the prompt. When the prompt appears, you can configure and manage thefirewall.NOTE:• To access the extended Boot menu (also called the "main BootWare menu"), press Ctrl+B immediatelyafter "Press Ctrl+B to enter extended boot menu" is displayed. If you fail to press Ctrl+B timely, thedevice automatically starts up. You must reboot the firewall if you still want to access the extended Bootmenu.• The boot information depends on the software version.Logging in to the CLI by using TelnetThis section provides only a simplified procedure for logging in to the CLI by using Telnet. For moreinformation, see the firewall configuration guides.To log in to the CLI by using Telnet:1. Log in to the firewall through the console port, execute the telnet server enable command in systemview to enable the Telnet service, and execute the user privilege level command in VTY userinterface view to specify the command level for Telnet users. By default, the Telnet service isdisabled on the firewall.2. Connect a PC to the firewall's management interface M-GigabitEthernet 0/0 by using a crossoverEthernet cable.3. Assign the PC an IP address in the network segment 192.168.0.0/24 (except for 192.168.0.1),for example, 192.168.0.2.4. Run the Telnet client on the PC to Telnet to the firewall.
