H3C WX3000 Installation Manual

Also see for WX3000 Series: Configuration guide Getting started guide Getting started guide Compliance and Safety Manual Installation manual

Contents

H3C WX3000 Installation Manual Manual pdf 18 page image

1-91000Base-X SFP port 10/100/1000Base-T Ethernet port28 23z The WX3010 provides eight 10/100/1000Base-T Ethernet ports and two 1000Base-X SFP ports.The electrical Ethernet ports support 10/100/1000 Mbps auto-sensing. The working modes of anEthernet port at different speeds are shown in Table 1-10.Table 1-10 Ethernet interface speeds and working modesInterface speed Working mode10 Mbps (auto-sensing) Half/full duplex auto-negotiation100 Mbps (auto-sensing) Half/full duplex auto-negotiation1000 Mbps (auto-sensing) Full duplex auto-negotiationz The WX3008 provides eight 10/100/1000Base-T Ethernet ports.The electrical Ethernet ports support 10/100/1000 Mbps auto-sensing. The working modes of anEthernet port at different speeds are shown in Table 1-10.The electrical Ethernet port status LEDs are above the RJ-45 sockets. The triangular pointer aboveeach LED indicates which port the LED is for.z The optical Ethernet ports of the WX3000 series support 100/1000 Mbps full duplex. The opticalport status LEDs are above the 1000Base-X SFP ports, each indicating the status of thecorresponding optical port.The support for the speed of optical Ethernet ports depends on the model of the optical transceivers.2) RJ-45 connectorsThe 10/100/1000M electrical Ethernet ports of the WX3000 series work with Category-5 twisted paircables with RJ-45 connectors, as shown in Figure 1-10.Figure 1-10 RJ-45 connector3) LC connectorsAs an indispensable passive component in a fiber communication system, a fiber connector is mainlyused for the removable connection between optical tunnels. This facilitates the testing and maintenance