HAKO Sweepmaster P650 (6403.10) Instruction Manual

24OperationDrive bar (Fig. 8/1)The drive bar serves to activate anddeactivate the wheel drive. The drivebar must be pulled up towards thehandlebar with the fingers so that thewheel drive operates and the machinemoves forward. If the drive bar isreleased, the machine stops (safetycircuit).Handlebar (Fig. 8/2)The machine is guide/steered via thehandlebar.Release the drive bar whenturning sharp corners.The two wing bolts (Fig. 8/4) serve toadjust the handlebar to an optimalposition for the user.Operating panel (Fig. 8/3)Refer to Section 3.2.2.Charger cable (Fig. 8/5)The charger cable of theSweepmaster B650 is located in therecess which also contains the shakingdevice lever.Shaking device lever (Fig. 8/6)To clean the panel air filter, pull theshaking device lever out then pushback in again; repeat this several times.Dirt hopper lock (Fig. 8/8)To remove the dirt hopper, move thelocking lever to the right (when facingthe front) and, at the same time pivotthe handlebar forwards. The frame ofthe dirt hoppers is lowered as a resultso that the hopper can be removedtowards the rear. To lock the hopper,pull the handlebar to the rear until thelock audibly engages.