Hach SC4200c User Instructions

Also see for SC4200c: Quick guide Basic user manual User manual User instructions User instructions

Contents

Hach SC4200c User Instructions Manual pdf 3 page image

Table of contentsSpecifications on page 3General information on page 3Installation on page 5Configuration on page 13SpecificationsSpecifications are subject to change without notice.Specification DetailsCurrent 23 mA maximumLinearity ± 0.05% of spanLoop resistance 12–18 VDC power supply: 0–250 Ω; 18–24 VDC power supply: 250–500 ΩWiring Wire gauge: 0.08 to 1.5 mm2 (28 to 16 AWG) with an insulation rating of 300 VAC orhigher1Operating temperature -20 to 60 °C (-4 to 140 °F); 95% relative humidity, non-condensingStorage temperature -20 to 70 °C (-4 to 158 °F); 95% relative humidity, non-condensingCertification Listed for use with the SC4200c controller in Class 1, Division 2, Group A, B, C and D,Zone 2, Group IIC hazardous locations to FM and CSA safety standards by ETLGeneral informationIn no event will the manufacturer be liable for direct, indirect, special, incidental or consequentialdamages resulting from any defect or omission in this manual. The manufacturer reserves the right tomake changes in this manual and the products it describes at any time, without notice or obligation.Revised editions are found on the manufacturer’s website.Safety informationN O T I C EThe manufacturer is not responsible for any damages due to misapplication or misuse of this product including,without limitation, direct, incidental and consequential damages, and disclaims such damages to the full extentpermitted under applicable law. The user is solely responsible to identify critical application risks and installappropriate mechanisms to protect processes during a possible equipment malfunction.Please read this entire manual before unpacking, setting up or operating this equipment. Payattention to all danger and caution statements. Failure to do so could result in serious injury to theoperator or damage to the equipment.Make sure that the protection provided by this equipment is not impaired. Do not use or install thisequipment in any manner other than that specified in this manual.Use of hazard informationD A N G E RIndicates a potentially or imminently hazardous situation which, if not avoided, will result in death or serious injury.1 Do not use wire gauge other than 0.08 to 1.5 mm2 (28 to 16 AWG), unless wires can be isolatedfrom mains power and relay circuits.English 3