Hafele 800 RH Assembly Manual

Hafele 800 RH Assembly Manual Manual pdf 1 page image

Before you start...Check the pack and make sure all the components and fixings are included – seealso fixings page 8, if not call the Helpline on 01788 548800 and our team will get things sorted. When you are readyto start make sure you have the right tools to hand, plenty of space and a clean dry area for building. Don't rush, readthe instructions first and run through the sequence before you begin. Assembly should be done in the stages shown in thefollowing diagrams, keeping fittings together to avoid loss.Cleaning - Use mild soap and water only. Do not use abrasive cleaners.FRAME C ASSMEBLYTake frame (C) and runner (I) extend the runner toits full extension and and secure the runner to frame(C) with 3 x M4 x 10 mm allen bolts as shown above.Attach damper (W) to bracket (V) with 2 x M4 x 10mm allen bolts and 2 x nyloc nuts (fig. 1). Attach (W)and (V) to frame (C) with 2 x M4 allen bolts (fig. 2).2Tape measureCross Head ScrewdriverBradawlA. Using a tape measure and pencil mark out 5 x 5 mmholes for the top plate (B) at a height of 510 mm, heightfrom hole centre to cabinet base as shown above. Pre drillusing a 5 mm drill bit. Do not fix the top plate at this point.B. Locate base plate (A) inline with the front edge of thecabinet. Pre drill 4 x 5 mm holes and secure with 4 xEuro screws.1Spirit levelAllen key (supplied) PencilTools required (Not Supplied)Component partsSoft close 800 RHPull & Swing Corner Unit• Make sure all the components are included beforeyou start.• The number for technical support is at the bottomof the page.• Don't rush!• Read the instructions first.• Assemble in the stages shown.• Keep the fittings together to avoid loss.• Have fun.Did you know Häfele also supply tools to the trade and industry?See www.hafele.co.uk for more information.FITT-10255Issue - 01Sales and Technical Support -Tel: 0800 171 2908, Fax: 01788 544440, E-Mail: info@hafele.co.uk, www.hafele.co.ukBLCE&FJKDG&HSOTQNMRIB5 mmA12VWXP**Please note:Runner (P) has a 3/4 extension, Runner(I) has a full length extension.A UAssembly guide