Haier AP482AKEAA Operation And Installation Manual

Also see for AP482AKEAA: Service manual Service manual

Haier AP482AKEAA Operation And Installation Manual Manual pdf 12 page image

Timer ON/OFF FunctionSet clock correctly before starting TIMER operation1.Unit startAfter unit start, select your desired operation mode (operationmode will be displayed on LCD)2.TIMER mode selectionPress TIMER button on the remote controller to change TIMERmode. Every time the button is pressed, display of TIMER modechanges as follows:ON OFF ON OFFAM 12:00 AM 12:00PM 12:00 PM 12:00TIMER ON TIMER OFF TIMER ON-OFFblankThen select TIMER mode as needed (TIMER ON or TIMER OFF).Now or will flash.4.Confirm setting5.Cancel TIMER modeJust press TIMER button several times until TIMER modedisappears.Hints:After replacing batteries or if a power failure occurs, TIMER setting must be reset.Remote controller has memory function. When you use TIMER mode next time, just press SETbutton after mode selection if timer setting is the same as the previous one.Note:After setting TIMER function, the remote controller displays TIMER time.ON OFFON OFFAfter setting correct time, press SET button to confirm time. Nowor stop flashing.Every time the button is pressed, time increases 1 minuts.If the button is kept pressed, time changes quickly.3.TIMER setting (press time adjust buttons )Every time the button is pressed, time decreases 1 minuts.If the button is kept pressed, time changes quickly.It can be adjusted within 24 hours at will.Manual Operation10OperationRemote controllerThe control panel will display TIMER.Control panelONOFFTEMPHEALTH FANMODESLEEP SWINGCLOCKTIMERSETLOCKLIGHTRESETHEAT1ONON/OFF MODE FANTEMPTEMP+ TEMP- HEALTHTIMER