REMOTE CONTROL PREPARATIONBATTERY INSTALLATIONInstall the battery as shown below. Be sure negative and positive terminals arepositioned as indicated in the battery compartment.(Fig1 )SERVICE LIFE OF BATTERIES-The batteries normally last for about one year although this depends on how often, andfor how long the remote control is used.-If the remote control fails to work even when it is operated near the player, replace thebatteries.-Use one size CR2025 battery.Note:Do not drop or step on the remote control. This may damage theparts or lead to malfunction.If the remote control is not going to be used for a long time, remove the battery.REMOTE CONTROLOPERATIONPoint the remote control from nomorethan about 6 meter from theremote control sensor and withinabout 60o of the front of theplayer(Fig2).NOTE:-The operating distance may varyaccording to the brightness of theroom.-Do not point bright lights at remotecontrol sensor.-Do not place objects between theremote control and the remotecontrol sensor.-Do not use this remote controlwhile simultaneously operating theremote control of any otherequipment.MAIN MENU• The unit contains different setting menus. Once the initial programming is entered it is retained inmemory until changed, the TV can always be operated under the same conditions.• The settings will be retained in the memory until the settings are changed even after setting the playerto the standby mode.Note: Please make sure either the unit is connected on the battery is charged to retain memory.Initial settings1.Press MENU button.2. Use the left or right button to select preferred page, each page has Sub Menu to select differentsetting. Then move the up or down button to set.3.Press MENU button again to return to current setting item.4.Press EXIT to close the setting menu .1. PICTURE SETUP-Press the MENU button the screen will display:-When the menu displays on the screen, press the MENU button again to exit.-Press EXIT to exit all menus.Picture modePress up or down button to select, then press left or right button to set the picture modeas Personal, Standard, Dynamic or Soft.Contrast/Brightness/Sharpness/Tint/Color-Press up or down button to select Contrast/Brightness/Sharpness/Color,then press left orright button to adjust..-The Contrast/Brightness/Sharpness/Color can be adjusted from 0-100.-The Tint can be adjusted from -50 to 50.1510