Haier HLT10 Instruction Manual

Contents

Haier HLT10 Instruction Manual Manual pdf 4 page image

PRECAUTIONS--TO PROLONG USE TIME, PLEASE MAKE SURE THE INTERVAL OFSWITCHING ON AND OFF IS NOT LESS THAN 5 SECONDS.--PROTECT THE POWER CORD FROM BEING WALKED ON OR PINCHED,PARTICULARLY AT PLUGS, CONVENIENCE RECEPTACLES, AND THE POINTWHERE THEY EXIT THE PRODUCT.USING OF POWER：-- DO NOT CONNECT TO POWER OVER PRESCRIPTIVE VOLTAGE, USE THECORRECT VOLTAGE AND CURRENT MARKED ON THE PRODUCT ELECTRICALRATINGS LABEL. ELECTRIC POWER OVERLOAD WILL CAUSE FIRE OR ELECTRICSHOCK.-- DO NOT PULL CABLES ,SHOULD HOLD PLUG WHEN USING POWER SOCKET.-- UNPLUG AC CABLE FROM POWER SOCKET IF NOT USE THE UNIT FOR LONGTIME.BATTERY USAGE AND HANDING:--KEEP BATTERY AWAY FROM CHILDREN AND PETS.--REMOVE THE BATTERY FROM THE REMOTE CONTROL WHEN THE PRODUCTWILL NOT BE USED FOR AN EXTENDED PERIOD.--NEVER THROW BATTERY INTO A FIRE. DO NOT EXPOSE BATTERY TO FIRE OROTHER HEAT SOURCES.FEATURES10.2″TFT DISPLAYBuilt in ATSC/NTSC Tuner.AUTO TV SCANNING FUNCTIONMEMORY FUNCTIONSUPPORT VIDEO/AUDIO INPUTDIGITAL BROADCASTING RECEPTIONGENERAL TROUBLESHOOTINGCheck the following points before assuming malfunctions of the TV set:Problem ReasonsNo picture & sound Improper connection of AC adaptor or the battery power is low.No picture Reception may not be adequate. Relate the unit or change the antennadirection.No sound Volume is too low; Mute function is switched on.The headphone has been plugged in or the signal is too weak .Poor reception TV antenna is not correctly adjusted or TV channel is not right.Dark or blurred picture The bright & contrast is too low. The battery voltage is too low.Unclear or unstablepictureTV antenna is not properly adjusted or in too weak signalreception area.Picture moves up &down,blurs or foldsoverTV antenna is not rightly adjusted.The signal reception is too weak or caused by signal reflectionfrom the buildings nearby or mountains.Interfered snowpictureThe signal is interfered by car,s engine, railway, high tensionwires, neon signs or radio frequency.No color Color or color system is not set properly.MAINTENANCE• Be sure to press POWER to set the player to the standby mode and disconnectthe AC adaptor before maintaining the player.• Wipe the player with a dry, soft cloth.• If the surfaces are extremely dirty ,wipe clean with a cloth which has beendipped in a weak soap-and-water solution and wrung out thoroughly, and thenwipe again with a dry cloth.• Never use alcohol, benzine, thinner, cleaning fluid or other chemicals. And donot use compressed air to remove dust.232