Haier HPRB07XC7 User Manual

Contents

EnglishAssembly and Installation1. Push the round Window Panel Adapter through the rear of the Plastic Panel.Line up the holes and tighten the Adapter with 4 screws that are included inthe kit. (Tighten screws from the front.)2. Adjust the Plastic Panel to the width or height of your window and tightenthe 2 screws that are attached to the panel.3. Install the Window Plastic Panel into the window. If necessary use duct tapeto better secure the panel.4. Connect exhaust hose to the unit by inserting the hose connector that isattached to the hose into the exhaust. (See Illustration A)5. Move the unit to the window, extend the hose and attach the other end ofthe hose to the window. Align the tabs on the hose and window paneladapters and fasten them together.6. Plug into wall outlet to get ready for operation.* NOTE: Use on Single Outlet Circuit Only.Accessories Include1. Plastic panel - 2 pieces2. Window Panel adapter - 1 piece3. Screws - 4 pieces4. Heat Exhaust hose connector - 2 pieces5. Heat Exhaust hose - 1 piece1 2Exhaust HoseHose Connector Hose Connector3AB64 5 4