Haier HSU-09LEA13-W - annexe 2 Installation Manual

Also see for HSU-05LEA03: Operation manual Installation manual Installation manual Operation manual Installation manual

Contents

Haier HSU-09LEA13-W - annexe 2 Installation Manual Manual pdf 2 page image

Floor fixing dimensionsof the outdoor unit(Unit:mm)HSU-12LEA03Floor fixing dimensionsof the outdoor unit(Unit:mm)HSU-18LEA03140 500 140652HSU-22LEA03For 22k,24k15.88mm(5/8")9.52mm(3/8")113.5 583 113.55.913Fixing of outdoor unitIndoor Unit Selection of Installation PlacePower SourceSelection of pipeOutdoor UnitFix the unit to concrete or block with bolts( 10mm) and nuts firmly and horizontally.When fitting the unit to wall surface, roof or rooftop, fix a supporter surely with nailsor wires in consideration of earthquake and strong wind.If vibration may affect the house, fix the unit by attaching a vibration-proof mat.Place, robust not causing vibration, where the body can be supportedsufficiently.Place, not affected by heat or steam generated in the vicinity, whereinlet and outlet of the unit are not disturbed.Place, possible to drain easily, where piping can be connected with theoutdoor unit.Place, where cold air can be spread in a room entirely.Place, nearby a power receptacle, with enough space around. (Referto drawings).Place where the distance of more than lm from televisions, radios,wireless apparatuses and fluorescent lamps can be left.In the case of fixing the remote controller on a wall, place where theindoor unit can receive signals when the fluorescent lamps in the roomare lightened.Place, which is less affected by rain or direct sunlight and issufficiently ventilated.Place, possible to bear the unit, where vibration and noise arenot increased.Place, where discharged wind and noise do not cause anuisance to the neighbors.Place, where a distance marked is available as illustratedin the above figure.Before inserting power plug into receptacle, check the voltage without fail. The power source is the same as the corresponding name plate.Install an exclusive branch circuit of the power.A receptacle shall be set up in a distance where the power cable can be reached. Do not extend the cable by cutting it.To this unit, both liquid and gas pipes shall be insulatedas they become Iow temperature in operation.Use optional parts for piping set or pipes covered withequivalent insulation material.2Floor fixing dimensionsof the outdoor unit(Unit:mm)HSU-05LEA03HSU-07LEA03HSU-09LEA03Liquid pipe ( )For 5k,7k,9k6.35mm(1/4")Gas pipe ( ) 9.52mm(3/8")For 12k,18k6.35mm(1/4")12.7mm(1/2")140 140415082HSU-24LEA03HSU-102LD08 HSU-122LD08HSU-182LD08HSU-222LD08HSU-09LEA13-WHSU-12LEA13-W HSU-18LEA13-WHSU-22LEA13-W