Haier HSU-18H03/R - annexe 1 Operation Manual

Also see for HSU-18H03-R: Installation manual

Contents

Haier HSU-18H03/R - annexe 1 Operation Manual Manual pdf 9 page image

Operation2.The purification function of AIP:DC high voltage bring high voltage electrostatic field, whichionize air into positive and negative ion. a great deal ofpositive and negative ion adhere to dust passing by, so thedust become "particle with electric charge". so the dustpassing by adheres to the AIP board under the force fromthe electric field, which purifies the unit.3.When power off, press the purify button, the Remotecontroller shows "FAN, low, AIP, and negative ion", andthe TIMER function is available.2.Health anion functionBRIEF INTRODUCTION TO AIR IONIZATION PURIFY ANDHEALTH ANION FUNCTION1.The anion generator in the air conditioner can generatea lot of anion effectively balance the quantity of positionand anion in the air and also to kill bacteria and speed upthe dust sediment in the room and finally clean the air inthe room.Press ON/OFF on the remote controller, unit starts.Press Purify button. is displayed on the remotecontroller and is displayed on the displayboard . Air conditioner starts air ionization purify andhealth anion function operation.1.Unit startDisplay boardRemote controllerFor twice press, and disappear,the operation stops.HEALTH operationPOWER/SOFTFRESHPURIFY83.Change-for-fresh-air functionPress FRESH button , " "displayed on the remotecontroller and the change-for-fresh-air function operation begins.For twice press , the display " "disappears and thechange-for-fresh-air function operation is canceled.note：If the unit didn’t install change-for-fresh-air electrical engine,change-for-fresh-air function is not available.When the fan in the indoor unit does not work, the health lamplights up, but the anion generator does not release anion.When indoor fan motor is running, it has healthyprocess function. (It's available under any mode)1)After the change-for-fresh-air function is initiated, the outside air canenter the indoors through the change-for-fresh-air tube therebykeeping the indoor air fresh.4.About change-for-fresh-air function2)Setting the change-for-fresh-air function under the shutdown status:Under shutdown status, press the fresh air key and the remotecontroller displays the on status of air flow, low wind, and change-for-fresh-air functions, and now can set the timing open, timingclose and time control switch. Press on-off button to cancel thechange-for-fresh-air function.