Haier HSU18VHJ Operational Manual

Also see for HSU12VHJ: Service manual Installation manual Installation manual Operation manual

Contents

5OperationHealthy airflow OperationSet clock correctly before starting TIMER operation.1.After unit starts, select your desired operation mode.2.Press TIMER button to change TIMER mode. Everytime the button is pressed, display changes as follows:Remote controller:BLANKTIMER ON TIMER OFF TIMER ON-OFFThen select your desired TIMER mode (TIMER ON orTIMER OFF or TIMER ON-OFF). " "or " "will flash.It can be adjusted within 24 hours.4.After setting correct time, press SET button to confirm" "or" " on the remote controller stops flashing.5.Cancel TIMER modeJust press TIMER button several times until TIMER modedisappears.Hints:After replacing batteries or a power failure happens, timesetting should be reset.Remote controller possesses memory function,when useTIMER mode next time, just press SET button after modeselecting if time setting is the same as previous one.According to the Time setting sequence of TIMER ON orTIMER OFF, either Start-Stop or Stop-Start can beachieved.Timer On/Off On-Off Operation1.Press ON/OFF to startingSetting the comfort work conditions.2.The setting of healthy airflow function1).Press the button of healthy airflow, appears on thedisplay. Horizontal airflow sending. Avoid the airflowblows direct to the body.2).Press the button of healthy airflow again, appears onthe display. Downward airflow sending. Avoid the airflowNote:1.After setting the healthy airflow function, the positiongrill is fixed.4.In cooling and dry, using the air conditioner for a longtime under the high air humidity, condensate water mayoccur at the grille .3.The cancel of the healthy airflow functionPress the button of healthy airflow again, the unit goes onworking under the condition before the setting of healthyairflow function.Notice: Do not direct the flap by hand. Otherwise, thegrille will run incorrectly. If the grille is not run correctly, stopfor a minute and then start, adjusting by remotecontroller.blows direct to the body.2.In heating, it is better to select the3.In cooling, it is better to select themode.mode.3.Press HOUR button to set time.