Haier LE32K700 Owner's Manual
                  | |
Remote ControlTelecontrol battery installation methodTake off the cover of battery box, fix two AAA batteries with 1.5 volt, and conform with the polarity ofremote control battery box.Note: Appearance of the remote control may be different from this picture, please according topracticality.Precautions for use of remote control1. When using remote control you should point it to the remote-control inductive window. The goodsbetween remote control and inductive window may hinder normal operation.2. Do not cause the remote control to receive fierce vibration. In addition, do not set or place theremote control under direct sunlight, for the thermal energy will cause the distortion of remotecontrol.3. When remote-control inductive window of main machine is under direct sunlight or intenseillumination, the remote control may malfunction, by now, please change the angle of illuminationor this machine, or approach the inductive window to operate the remote control.4. When the battery voltage is insufficiency it influences the remote control distance, you shouldreplace with new battery; when not to use the remote control for long or the battery is exhausted,please take out the battery, in order to avoid bringing the battery leakage to corrode the remotecontrol and thus cause it out of commission.5. Do not use different batteries. The mix use of new and old batteries is not allowed, you shoulduse battery pair.6. Do not throw battery into fire, charge or disassembly, especially do not charge, assemble anddisassemble, heat or burn to the used battery. Please observe the related environmentalprotection stipulation on wasted battery.Basic Operation InstructionPlug power cord into the electrical socket and press '' '' key on the control panel, then press '' ''key on the remote control to turn on the TV.Press ''Power''key on the remote control. TV will be in standby.ā
Special Attention:1.TV will automatically turn to standby if there is no signal input for 5 minutes when TV turns on.2.T rn to standby when thePress ''SOURCE'' key either on the remote control or on the control panel, thenmenu of signal source will be displayed on the screen. Then press ''Up/Down''key on remote control or "CH+/CH-" key on the control panel to choose thesignal source. Press ''OK'' key on the remote control or ''MENU" key on thecontrol panel and TV will switch the current signal source to the signal sourceyou choose.setV set will automatically tu preset time of turning off reaches.Signal Source SelectionStandbyPower On8Input SourceTVAVYPbPrPCHDMI1HDMI2USB |
Related manuals for Haier LE32K700
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine