Haier P60A11-AK Owner's Manual

Other functionsDisplay functionPress the DISPLAY button, then the channel number andsystem will be displayed on the screen.Press again,it is disappear.the DISPLAY buttonPress the I/II button will result in fast swap of NICAM function of current program.NICAM303AUTOB/GSleepThe TV set will switch automatically to standby at the preset time with the SLEEPtimer on. You may set the sleep time.each press of SLEEP button repeatedly on the remote control to select the number ofpreset minutes, the time will be set in sequence: (off, 10, 20, 30,60, 90, 120,150,180).To confirm the sleep time setting, press SLEEP and the remaining time will be displayedfor a few seconds.To cancel the sleep time, press SLEEP repeatedly until the display turns to off.Press the STILL button, the STILL will display on the screen,at this time, the picture of TV is still, and press the STILL buttonagain, the picture will resume.STILLChannel edit setup0 ------1 ------2 ------3 ------4 ------5 ------6 ------7 ------No Channel Name1 Press CH.EDIT button to open/close the Channel Name menu,Note opens when automatically will select the current channelnumber.2 Press CH+/- button to select the desired channel number, and thenpress OK button to confirm.3 Press VOL+ button to move the cursor, and then use CH+/- buttonto alter the letter.4 When you are satisfied with your change, press the EXIT button toreturn to normal viewing or press MENU button to return to theprevious menu.ScanThis function fast glances over the channels(Skip as off) which each searches.Press the SCAN button to start from the current channel, and switch a channel every 3seconds, after scanning, and the program channel stop the current channel.If you want to stop the function during auto tunning, simply press Scan or MENU buttonagain, at this time, the program will stop the program Finally glances over.