Hakko Electronics FM-203 Instruction Manual

Contents

Hakko Electronics FM-203 Instruction Manual Manual pdf 5 page image

60Connecting cableJack to Connecting cableA. Iron holder● Loosen the adjusting screws to change theangle of the iron receptacle as you like, thentighten the screws.1. Assemble as shown:● Insert the holder assembly securely into theIron holder base.2. Operation:First, remove any excess solder from the tip bythrusting the tip into the cleaning wire.(Do not wipe the tip against the wire. This maycause molten solder to spatter.)When the wire becomes dirty or loaded withsolder, turn the wire until a clean surface ispresented.When changing the cleaning wire, lift the casetop vertically to prevent solder debris fromfalling out.3. Place the spare tips in the tip tray.● Use of the sleep functionWhen using the sleep function, insert one endof the connecting cable into the jack at theback of the iron holder and the other end intothe jack at the back of the soldering station toconnect them.CAUTION• Be sure to turn off the power before connecting ordisconnecting the connecting cable.• Securely insert the connecting cable all the way in to thejack.B. Connector cord● Pass the connector cord through the hole inthe heat resistant pad.4. INITIAL SETUP日本文中文 English