Hameg HM6050-2 Manual
Also see for HM6050-2: User manualUser manualManualManual
              | |
Contents
| 
22 Subject to change without noticeOperating ManualIntroductionIt is highly recommended to read this operating manual before usingthe HM6050-2. After unpacking the equipment check for any mechanicaldamage or loose parts inside. Should there be a transportation damage,inform the supplier immediately. Do not put the equipment intooperation.Used SymbolsATTENTON – refer to manualProtective ground (earth) terminalL1/N – identification of power lines(Lit, if the power cable connector is pluggedin correctly (phase))Operation according to rulesThe Line Impedance Stabilization Network HM6050-2 has to beoperated according to the regulations as defined in VDE 0876 Part1(”Measurement of radiated emissions”). It conforms to the regulationsas defined in CISPR Publ.16 or. EN55011.SafetyThis instrument has been designed and tested in accordance with VDE0411 Part 1, Safety requirements for electrical equipment formeasurement, control, and laboratory use. The CENELEC regulationsEN 61010-1, international standard IEC 1010-1 res. correspond to thisstandard. All case and chassis parts are connected to the safety earthconnector of the power line plug, corresponding to the Safety Class 1regulations.To put the HM6050-2 to operation it has to be connected to anAC power outlet (with protective ground) according to VDE-0100.Due to the relative high leakage current (ca. 800 mA) the equip-ment cannot be operated in combination with a leakage currentcircuit breaker. Thus, “protective ground” is equiva-lent to“earth”.Any interruption of the protective ground conductor inside oroutside the instrument is prohibited. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine