Handy Tech Braille Wave User Manual
Also see for Braille Wave: User manualUser manualUser manual
                                                                                                             | |
Contents
| 
HandyTechElektronikGmbHBraille WaveThe Braille System as Braille DisplayPage 84Mobile Phone Keys (Description) Braille System KeysPlace the cursor at thecorresponding text position.Begin marking text (beginning ofblock) by pressing the CR key abovethe cursor position (end of block isset by activating any CR key).Activate a menu item.CR7.4.4 Useful Tips for Using Talks Premium If you want to mark a block of text for copying, cutting, or deleting, press the cursorrouting key at the beginning of the desired block to position the cursor at thatlocation. By pressing the same cursor routing key again, you activate the markingfunction, and the identification letter on the Braille display changes from "T" to "S" toindicate this. Next, press the cursor routing key at the end of the desired text block.The marked block will now be underlined with dots 7 and 8. You should executewhichever block function you were planning now, before moving the Braille displayanywhere else, because otherwise the cursor will be moved along with the Brailleoutput, and thus the marked block will be lost. If you change the active application, or if you change the marked position, TalksPremium will automatically show the marked position on the Braille display. If nomarked block is available, the title of the active window will be displayed. Utilizing only the Braille display, without voice output, significantly speeds up theoperation of the mobile phone. As long as you are using Braille output, we thereforerecommend turning voice output off.7.5 CONFIG MODEConfiguration mode can be activated from PC mode by holding down [3 7] for longer than3 seconds. Immediately after these are held down, a short signal tone will sound — onceconfiguration mode has been entered, a long signal tone sounds. Also, the message'CONFIG MODE' appears on the Braille display.Note:Please note that any settings changes you enter in configuration mode have a significanteffect on the operation of the Braille System. Make sure that you are completely certainwhat these effects will be before you make any changes.The keys on the Braille System now have the following functions (non-functional keys arenot listed):[7] Exit configuration mode.A short signal tone will sound. The new menu settings will be in force.[2] Energy saving mode on/offIf energy saving mode is turned on, the Braille System is automatically turnedoff after a certain period of inactivity. Details are contained in chapter 3.3.9.The Braille display will confirm the setting by showing: |
Related manuals for Handy Tech Braille Wave
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine