Harbor Breeze 40956 Installation Manual

Contents

Harbor Breeze 40956 Installation Manual Manual pdf 10 page image

10STANDARD OR ANGLE MOUNTING INSTRUCTIONS4. Depending on the length of downrod you use, youmay need to cut the lead wires back to simplify thewiring. If you decide to cut back the lead wires, it issuggested you do so in the following manner: Takethe lead wires and make sure you have pulled themall the way through the top of the downrod. Measure8 inches of lead wire, then cut the excess wire off withwire cutters (not included).5. Note: If you did not cut back the lead wires in Step 4,Step 5 is not necessary and you may proceed to Step 6.If you decided to cut back the lead wire in Step 4, strip1/2 in. of insulation from the end of the white wire.Twist the stripped ends of each strand of wire withinthe insulation with pliers (not included). Repeat thisstep for black, blue and green wires.6. Install the ball end of the downrod (A) into the openingof mounting bracket (D). Align one of the four slots inthe ball with the tab in the mounting bracket (D).Note: The downrod (A) should not rotate if installedcorrectly.DANGER: Failure to align the slot in thedownrod (A) with the tab of the mounting bracket (D)may cause the fan to wobble or fall, which could resultin serious injury or death.Proceed to the Wiring on page 12.456AADDTabSlot8 in.