Hardi FOAM MARKER Standard Operator's Manual

28 HARDI® FOAM MARKER STANDARD VERSION(A) (A)10.2 Falcon or MB Booms- For fi tting the Foam Dropper mount bracket to the Falcon or MBBoom outer wing the following kit is required (Kit #741526)- These components are to substitute the mount bracket which is fit-ted to the Foam Dropper assembly. Mount the new components asshown in (Fig. 26) and discard the unused components.- Mount the Foam Dropper mount bracket as close to the outer nozzleas possible (Fig. 27).- Adjust the breakaway tension by tightening or loosening the pivot bolt.- Connect the clear reinforced hose to the 3/ 4 ”90° hose barb on the Foam Dropper assemblyand to the 3/4 ” hose barb on the Foam Genera-tor assembly.- Secure the hose with cable ties as necessary.- Connect the polyethylene 8mm and 10mmhoses to the fittings at the base of the FoamGenerator.10.3 Force™ or Twin Force Booms- A mount tab (A) for the Foam Dropper as-sembly is fixed to the outer edge of the breakaway frame. The FoamDropper assembly is to be removed from the mount bracket arm andrefitted to the mount tab (Fig. 28).- connect the clear reinforced hose to the 3 / 4” 90° hose barb on theFoam Dropper assembly and to the 3 /4” hose barb on the Foam Gen-erator assembly.- Secure the hose with cable ties as necessary.- connect the polyethylene 8mm and 10mm hoses to the fittings at thebase of the Foam Generator.Fig. 28Fig. 27