4 - Sprayer setup4.8WARNING! Securely support the sprayer during axle adjustments. Never attempt to adjust axles with liquid in thetank. Always block wheels on opposite side when adjusting axles.ATrack width cannot be altered by turning rim and rim plate. The rimplate can be fitted left or right. With an offset of :+ 6”- 5.5”Turning rim and rim plateThe track width of the RANGER can be adjusted from 60” to 90” in 2”increments as follows:1. Measure the current track width (center RH tire to center LH tire).Each side must be extended or retracted half the desired alteration.2. Attach the sprayer to tractor and engage tractor parking brake.3. Place stop wedges in front of, and behind RH wheel. Jack upframe behind LH wheel, support and secure sprayer body.4. Remove bolts (A) for LH axle insert.5. Extend or retract the axle.6. Replace bolts (A) and tighten to specified torque.7. Repeat the procedure on RH wheel.8. Check if the distance from center tire to center of rear frame isequal at RH and LH.9. Retighten bolts and wheel bolts to specified torque after 8 hoursof work.Altering the track widthTrack width, axles and wheels
