INSTALLATIONEmber PlacementWARNING: IMPROPER INSTALLATION OFTHE EMBER MATERIAL MAY LEAD TOCARBON MONOXIDE POISONING.1. Tear the Ember Material into 10 to 12individual pieces (Fig 1).2. Slightly stretch each Ember piece so it can beplaced on the front burner ports and be supportedby the front grate and burner (Fig. 1 & 2).3. Place the pieces of Ember Material evenlyacross the front burner so as many front burnerports can be covered as possible. (Fig 3 & 4)DO NOT PRESS THE EMBER MATERIAL INTOTHE BURNER PORTS.WARNING: DO NOT PUT ANY ADDITIONALEMBER MATERIAL ON THE BURNERSYSTEM. USE ONLY WHAT WAS PROVIDEDWITH THE SET. PLACING ADDITIONALEMBER MATERIAL ON THE SET MAY CAUSEIMPROPER COMBUSTION AND WILL VOIDTHE MANUFACTURER’S WARRANTY.4. You may place some ember material on thetube that connects the front and back burner. Donot press the ember material into the ports as itmay obstruct the ignition of the front burner.DO NOT PLACE ANY EMBER MATERIAL ONTHE BACK BURNER (Fig. 3)Fig. 1EMBER PIECEActualSizeFig. 2Front Burner/Burner PortsFront GrateFront Burner with Embers Properly InstalledDO NOT PLACE ANY EMBERMATERIAL ON BACK BURNER!Fig. 3 Fig. 41110