Harman Kardon AVR 247 Owner's Manual

Also see for AVR 247: Brochure & specs Catalog Service manual Owner's manual Worksheet

Harman Kardon AVR 247 Owner's Manual Manual pdf 6 page image

6 FRONT PANEL CONTROLS1 Main Power Switch: Press this button toapply power to the AVR. When the switch ispressed in, the unit is placed in a Standbymode, as indicated by the orange LED 3. Thisbutton MUST be pressed in to operate the unit.To turn the unit off completely and prevent theuse of the remote control, this switch should bepressed until it pops out from the front panel sothat the word “OFF” may be read at the top ofthe switch.NOTE: This switch is normally left in the “ON”position.2 System Power Control: When the MainPower Switch 1 is “ON,” press this button toturn on the AVR; press it again to turn the unitoff (to Standby). Note that the Power Indicator3 will turn blue when the unit is on.3 Power Indicator: This LED will be illuminatedin orange when the unit is in the Standby modeto signal that the unit is ready to be turned on.When the unit is in operation, the indicator willturn blue.4 Headphone Jack: This jack may be used tolisten to the AVR’s output through a pair of head-phones. Be certain that the headphones have astandard 6.3 mm stereo phone plug. Note thatthe speakers will automatically be turned offwhen the headphones are connected.When configuring your system using EzSet/EQ,the calibration microphone should be pluggedinto this jack using the supplied adaptor thatconverts the small mini-plug at the end of themicrophone’s cord to a 1/4" plug.5 Surround Mode Group Selector: Pressthis button to select the top-level group ofsurround modes. Each press of the button willselect a major mode grouping in the followingorder:Dolby Modes ➜ DTS Digital Modes ➜ DSPModes ➜ Stereo Modes ➜ Logic 7 ModesOnce the button is pressed so that the name ofthe desired surround mode group appears in theMain Information Display Ò, press theSurround Mode Selector 9 to cycle throughthe individual modes available. For example, pressthis button to select Dolby modes, and then pressthe Surround Mode Selector 9 to choosefrom the various mode options.6 Speaker Select Button: Press this buttonto begin the process of selecting the speakerpositions that are used in your listening room.(See page 29 for more information on setup andconfiguration.)Front Panel Controls123456789)!@#$%^&*(ÓÔÒÚÛÙıMain Power SwitchSystem Power ControlPower IndicatorHeadphone JackSurround Mode Group SelectorSpeaker Select ButtonSelector ButtonsTone ModeSurround Mode SelectorTuningTuner Band SelectorSet ButtonPreset Stations SelectorSpeaker/Channel Input IndicatorInput Source SelectorRDS Select ButtonDelayDigital Optical 3 InputSurround Mode IndicatorsDigital Coax 3 InputVideo 4 input jacksInput IndicatorsMain Information DisplayRemote Sensor WindowDigital Input SelectorChannel Select ButtonVolume ControlDIGITAL LOGIC 7 VID 1 DVDCDFMAMTAPE6 8 CHVID 2VID 3VID 4PRO LOGIC3 STEREOHEADPHONEDSP5 7 CH. STEREOSURR. OFFOptical 3 Coaxial 3