Harman Kardon AVR 3600 Owner's Manual

Also see for AVR 3600: Service manual Worksheet User manual

Harman Kardon AVR 3600 Owner's Manual Manual pdf 47 page image

47ADVANCED FUNCTIONSNOTE: Use caution when programming complicated activities.It isn’t possible to program a pause or delay before sendingcommands after Power On, and the component may not beready to respond to commands immediately after powering on.To program, or “record” an activity, follow these steps:1. To enter Program mode, simultaneously press and hold theActivity Button and the Alphanumeric Key or AVR Power On or OffButton to which the activity will be assigned.2. Press the Source Selector (or Setup Button) for each devicebefore you enter individual commands. This step counts as oneof the 19 commands allowed for each activity.3. For Power On, press the AVR or Device Power On Button.4. Press the AVR or Device Power Off Button for Power Off.5. Press the Activity Button to end the programming process, andthe last Source Selector (or the Setup Button) will flash threetimes.It isn’t possible to “edit” a command within an activity. To erase theactivity:1. Press and hold the Activity Button and the Alphanumeric Key orAVR Power On or Off Button until the Source Selector or SetupButton lights.2. Press the Activity Button to erase the activity.To execute an activity, press the Activity Button, then press theAlphanumeric Key (or the AVR Power On or Off Button) for theActivity.LearningIf you have programmed a product’s codes into the remote and findthat some functions are missing, the AVR 3600 remote may “learn”individual codes from the product’s original remote. See page 26.Resetting the RemoteTo reset the remote to its factory defaults, simultaneously press andhold the TV Source Selector and the “0” Alphanumeric Key. Whenthe TV Button re-lights, enter the code “333”. When the TV Buttongoes out, and all of the Source Selectors flash, the remote will bereset.PROCESSOR RESETIf the unit behaves erratically after a power surge, first tun off theMain Power Switch and unplug the AC power cord for at least3 minutes. Plug the cord back in and turn the receiver on. If thisdoesn’t help, reset the AVR.NOTE: A system reset erases all user configurations, includ-ing video resolution, speaker and level settings, and tunerpresets. After a reset, reenter all of these settings from yournotes in the appendix worksheets.To reset the AVR 3600, place it in Standby mode (press the front-panel Standby/On Switch so that the Power Indicator turns amber).Then press and hold the front-panel OK Button for at least 5 secondsuntil the RESET message appears.If the receiver does not function correctly ofter a processor reset,contact an authorized Harman Kardon service center for assistanceAuthorized service centers may be located by visiting the Web siteat www.harmankardon.com.NOTE: After performing a system reset, wait at least 1 minutebefore pressing any Source Selectors.MEMORYIf the AVR 3600 is unplugged or experiences a power outage, it willretain user settings for up to four weeks.