Erase a macro as follows:1. Simultaneously press and hold the Activity Button and the Numeric Key orAVR Power On Button assigned to the activity until the Source Selector or AVRSettings Button lights.2. Press the Activity Button to erase the macro.Resetting the RemoteTo reset the remote to its factory defaults, simultaneously press and hold the TVSource Selector and the “0” Alphanumeric Key. When the TV Button re-lights,enter the code “333”. When the TV Button goes out, and all of the SourceSelectors flash, the remote will have been fully reset.Processor ResetThere may be instances when you wish to fully reset the AVR 354 to its factorydefaults, or the unit may behave erratically after a power surge. To correct erraticbehavior, first try turning the Master Power Switch off and unplugging the ACpower cord for at least three minutes. Plug the cord back in and turn the receiverback on. If this doesn’t help, try a system reset.NOTES:• A system reset erases all user configurations, including video resolution,speaker and level settings, and tuner presets. After a reset, you will needto reenter all of these settings.• The RS-232 Reset Button on the rear panel of the AVR 354 does notperform a system reset. DO NOT press the RS-232 Reset Button.To reset the AVR 354, place the receiver in Standby mode (press the front-panel Standby/On Switch so that the Power Indicator turns amber).Then press and hold the front-panel OK Button for at least five seconds until theRESET message appears in the display.Follow the directions in the owner’s manual on page 34 to restore the picture ifnecessary.If the receiver still does not function correctly after a processor reset, contact anauthorized Harman Kardon service center for assistance.Authorized service centers may be located by visiting our Web site atwww.harmankardon.com.MemoryIf the AVR 354 is unplugged or experiences a power outage, it will retain usersettings for up to four weeks.34AVR354 harman/kardon