REAR PANEL CONNECTIONS 9 CLASS 1 LASER PRODUCTKLASSE 1 LASER PRODUKTLUOKAN 1 LASER LAITEKLASS 1 LASER APPARAT20 /60TV SCART¡ Optical Digital Output™ Coaxial Digital Output£ Analog Audio Outputs¢ Composite Video Output∞ S-Video Output§ AC Power Cord¶ Scart TV Output• Remote Control Outputª Remote Control Input¡ Optical Digital Output: Connect this jackto the optical digital input of an A/V receiver orsurround processor for Dolby Digital, DTS orPCM audio playback.™ Coaxial Digital Output: Connect this jackto the coaxial digital input of an A/V receiver orsurround processor for Dolby Digital, DTS orPCM audio playback.NOTE: The coaxial digital output should only beconnected to a digital input. Even though it isthe same RCA-type connector as standard ana-log audio connections, DO NOT connect it to aconventional analog input jack.£ Analog Audio Outputs: Connect thesejacks to an audio input on an A/V receiver orsurround processor for analog audio playback.¢ Composite Video Output: Connect thisjack to the video input on a television or videoprojector, or to a video input on an A/V receiveror processor if you are using that type of devicefor video input switching.∞ S-Video Output: Connect this jack to theS-Video input on a television or video projector,or to an S-Video input on an A/V receiver orprocessor if you are using that type of device forS-Video input switching.§ AC Power Cord: Connect this plug to anAC outlet. If the outlet is controlled by a switch,make certain that it is in the ON position.Note: You’ll find more details about allAudio/Video connections under Setup andConnections on the following pages.¶ SCART OUT (TV SCART): If your TV has aSCART socket, you can connect a SCART cable toyour TV and to your DVD Player for improvedvideo quality. The SCART cable carries bothaudio and video. You can select Composite Videoor RGB video for that SCART connector’s videooutput signal (see page 16).• Remote Control Output: Connect thisjack to the infrared (IR) input jack of anothercompatible Harman Kardon remote controlledproduct to have the built-in Remote Sensor onthe DVD player provide IR signals to othercompatible products.ª Remote Control Input: Connect the out-put of a remote infrared sensor, or the remotecontrol output of another compatible HarmanKardon product, to this jack. This will enable theremote control to operate even when the frontpanel Remote Sensor on the DVD player isblocked. This jack may also be used withcompatible IR remote control-based automationsystems.Rear Panel Connections